Franke FBFP A52 Manual De Uso página 12

4. CONTROLS
Key Key press
L Short
Long press with
lights on
Long press with
all loads off (mo-
tor and lights)
T1 Short
Long press with
light on
Long press with
all loads off (mo-
tor and lights)
T2 Short
Long press with
light or motor on
Long press with
all loads off (mo-
tor and lights)
12
Function
The lights alternate between high intensity, medium intensity (if
present), off.
If there is an induction cooktop coupled with the hood and the hood is
off, as soon as the induction cooktop is turned on, the hood lights
automatically turn on at the maximum intensity.
It is possible to change the intensity of the light cyclically. Using long
separate presses it is possible to vary the tone of the light between
"warm" and "cold".
Connected mode coupling
Before starting the procedure follow the specific instructions of the
manuals of the devices to be coupled.
The procedure for pairing of the hood with compatible devices (re-
mote control) starts. Only one remote control can be paired. See the
manual of the devices for details of the operations that need to be
performed on these.
The coupling procedure takes 2 minutes. If no devices are recognised
within this time check that you have previously activated the proced-
ure for the devices to be coupled. The maximum number of linkable
devices may have been reached.
Turns the motor on/off at the first speed.
Activates/Deactivates the Activated Carbon Filters alarm.
Connected mode decoupling
The procedure for deleting all compatible devices previously associ-
ated with the coupling function begins.
Turns the motor on/off at the second speed.
24h Function
Activates/Deactivates the motor in the 24h Air Exchange mode, a
speed that allows suction of 10 minutes every hour, for a 24-hour
cycle.
Cannot be activated if the Intensive or Delay modes are active.
Wi-Fi connection
Activates/Deactivates the Wi-Fi Connection function.
Note: the Wi-Fi function is automatically activated when the user re-
quests the Wi-Fi configuration procedure.
LED
-
Flashing
LEDs T1 and T2 flash-
ing:
coupling in progress.
Upon successful com-
pletion of the procedure
LEDs T1 and T2 will
light up for 2 seconds.
Fixed
All LEDs flash twice:
alarm activated.
All LEDs lit for 1
second:
alarm deactivated.
Upon successful com-
pletion of the procedure
LEDs T1 and T2 flash 5
times.
Fixed
Flashing
LED S1 Flashing:
connection to domestic
network in progress.
LED S1 Fixed: Wi-Fi
connection activated.