Cleaning; Cleaning The Machine; Cleaning The Grass Catcher - ST R72 Li 48 V1 Manual De Instrucciones

60% ≤ SOC < 80%
40% ≤ SOC < 60%
20% ≤ SOC < 40%
10% ≤ SOC < 20%
NOTICE
Battery charging times may increase if
the machine has been used in heavy-duty
work conditions with consequent indication
of battery overheating (chap. 15).
NOTICE
If a battery becomes completely discharged,
the signalling LEDs remain off until the
minimum charge threshold is reached.
NOTE
When the charge level drops below the
10% threshold, the first battery LED begins
flashing. Below the 4% threshold, the first
battery LED begins flashing rapidly and the
cutting means disengage. Stop mowing and
return to base to recharge the batteries.
When charging is complete, the charging
system turns off after 24 hours and
there is no automatic maintenance and
recharging of the battery charge.
NOTICE
If, when the battery charger is connected to
the tractor, the 5 LEDs fig. 7.F all flash at the
same time, it means charging is not in progress.
Check the battery charger/mains connection.
NOTE
While charging, all machine functions are
disabled, even when the key is fully inserted.
ATTENTION
The batteries mounted on the machine are
designed and manufactured for this type of use.
Inasmuch: :
- DO NOT replace the batteries with other non-
original batteries;
- DO NOT carry out interventions unless they
have been indicated in this manual.
In the event of any problems with the
batteries, contact your Dealer.

8.3 CLEANING

Clean thoroughly following the instructions
below every time it is used.

8.3.1 Cleaning the machine

• Clean the outside of the machine washing
the plastic parts of the bodywork with a
damp sponge using water and detergent,
taking care not to wet the electric motors, the
batteries or the parts of the electrical system.
• To reduce the risk of fire, keep the motors
and battery housings free of grass,
leaves residues or excessive grease.
• Keep the pushbutton panel
free of dirt and debris.
ATTENTION
Never use high pressure water or aggressive
fluids to wash the bodywork and electric motors.
8.3.2 Cleaning the unload chute
If the discharge chute is clogged:
1. remove the grass catcher or the
rear discharge guard;
2. remove the grass cuttings; you can reach
them from the chute discharge opening.

8.3.3 Cleaning the grass catcher

1. Empty the grass catcher.
2. Shake it to remove grass
cuttings and soil residue.
3. Replace the grass catcher and clean
the interior of the cutting means
assembly (par. 8.3.4-a), now remove
the grass catcher, empty and rinse it,
then place it where it can dry quickly.
8.3.4 Cleaning the cutting
means assembly
Clean cutting means assembly thoroughly
to remove any grass residue or debris.
WARNING
Keep people or animals away from
the surrounding area when cleaning
the cutting means assembly .
EN - 22