Publicidad
support@nextlevelracing.com
)
A
B
25
A) Align the rear Seat Slider assembly with the T-Nuts previously installed in Step 01a & Step 01b.
B) Bolt through and secure with 2 x Ratchet Handles.
26
Install 2 x T-Nuts into the front channel and 2 x T-Nuts into the rear channel of the Left Wheel Post.
Repeat for the Right Wheel Post.
)
)
A
B
Felt Pads
Note: Use level provided to ensure
the Wheel Assembly is kept flat during
installation to avoid skewing.
A) Install Felt Pads to the Mounting Arms to avoid scratching of Wheel Post when adjusting the height of the wheel.
27
B) Align the holes on the right Mounting Arm with the T-Nuts previously installed in Step 26. Bolt through and secure with 4 x
M8 Bolts and Washers. Repeat on the other side.
PARTS:
• • 2 x Seat Slider Ratchet Handles
Repeat
on Other
Side
)
PARTS:
• • 8 x M8 T-Nuts
PARTS:
• • Mounting Arms
• • 8 x M8 16mm Bolts
Repeat
on Other
Side
• • 8 x M8 Washers
• • 4 x Sticky Felt Pads
(90mm x 10mm)
18
FRONT MOUNT ASSEMBLY
)
A
B
28
A) Align the slots on the Front Mount Bracket with the mounting holes on your Front Mount Wheel Base.
B) Bolt through and secure with 4 x M8 Bolts and Washers
Note: Use level provided to ensure
the Wheel Assembly is kept flat during
installation to avoid skewing.
29
Align the Wheel Base Assembly with the slots on the Mounting Arms. Bolt through and secure with
4 x M8 Low Profile Bolts, Nylon Washers and Flange Nuts.
FRONT MOUNT ANGLE ADJUSTMENT
30
Loosen the Bolts securing the Side Mount Brackets to the Front Mount Brackets. Adjust the Wheel
Base to the desired angle and tighten the Bolts to lock in place.
19
Video Instruction: bit.ly/nlrbuild
PARTS:
• • Front Mount Bracket
)
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
.
PARTS:
• • 4 x M8 25mm Low Profile Bolts
• • 4 x M8 Nylon Washers
• • 4 x M8 Flange Nuts
PARTS:
• • NIL
Publicidad
