Publicidad
support@nextlevelracing.com
LEFT
REAR
IMPORTANT: Place T-Nuts as shown in diagram below on the OUTSIDE of the Right Base.
(Red dots are T-Nuts placement)
Note: Slide 2 x
T-Nuts to rear for
Seat Sliders
REAR
01b
Slide 8 x T-Nuts into the outside channel of the Right Base.
Note: For easier installation hand
screw M8 bolt in to T-Nut to assist
sliding T-Nut into channel.
FRONT
RIGHT
Note: Slide 4 x
Note: Slide 2 x
T-Nuts to middle for
T-Nuts to front for
Wheel Post
Pedal Support
FRONT
10
10
REAR
02
Align the threaded holes on the Front and Rear Base Members with the pre-drilled holes on the Right
Base Member. Bolt through and secure with 4 x M8 Bolts and Washers.
Note: Depress locater tab on back
side of clip to install into channel.
03
Suggested 1 x Cable Management Clip installation into the Rear or Front Base Member.
LEFT
REAR
04
Align the threaded holes on the Front and Rear Base Members with the pre-drilled holes on the Left
Base Member. Bolt through and secure with 4 x M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
FRONT
• • 4 x M8 40mm Bolts
• • 4 x M8 Washers
RIGHT
PARTS:
• • Cable Management Clips
PARTS:
• • 4 x M8 40mm Bolts
• • 4 x M8 Washers
RIGHT
11
11
Publicidad
