Publicidad
support@nextlevelracing.com
WHEEL ASSEMBLY HEIGHT ADJUSTMENT
Repeat
on Other
Side
Note: Support the Wheel Assembly while
adjusting to prevent it from slipping.
37
Loosen the Bolts securing the Mounting Arms to the Wheel Posts. Adjust to the desired position and
tighten the Bolts to secure in place.
38
Install 2 x T-Nuts in the front and rear outside channels of one of the Wheel Posts.
39
Align the mounting holes on the Tool Kit Holder with the T-Nuts previously installed in Step 38.
Bolt through and secure with 2 x M8 Bolts and Nylon Washers.
22
PARTS:
• • NIL
PARTS:
• • 2 x T-Nuts
40
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Nylon Washers
• • Tool Kit Holder
A: Align end-cap to
corner of extrusion.
YOUR COCKPIT IS COMPLETE
It's time to install your electronics. If you have any questions about your setup you
can contact us directly at: support@nextlevelracing.com or you can join the
community on Discord or Facebook
Your Setup is complete.
23
Video Instruction: bit.ly/nlrbuild
bit.ly/nlr-discord
bit.ly/NLRowner
B: Depress the centre
C: Finished End Cap.
of the end-cap and align
the tab to the first hole.
Then align second tab
with the second hole.
Publicidad
