Publicidad
support@nextlevelracing.com
PEDAL ADJUSTMENT RANGE
19
Loosen the Bolts securing the Pedal Plates. Adjust to the desired position using the alignment lines
and tighten the Bolts to lock in place.
20
Align the bottom mounting holes on the Pedal Adjustment Fins with the T-Nuts previously installed in
Step 01b. Bolt through and secure using M8 Bolts and Washers. Repeat on the other side.
PEDAL ANGLE ADJUSTMENT
Repeat
on Other
Side
21
Adjust the pedal assembly to the desired angle and align the T-Nuts previously installed in STEP 13
with the holes on the Pedal Adjustment Fins. Bolt through and secure with M8 Bolts and Washers.
PARTS:
• • NIL
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
Repeat
on Other
• • 2 x Pedal Adjustmen Fins
Side
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
16
)
)
A
B
(
)
Butt-Kicker T-Nut Locations
A) Install 2 x T-Nuts into the top channels of both Seat Sliders for future seat installation and 2 x T-Nuts into the bottom channel
22
of the front Seat Slider for the Butt-kicker Mount Pole. Attach Felt Pads to the bottom of the Seat Sliders.
B) Align the holes on the Seat Slider End Plates with the threaded holes on the Seat Sliders. Bolt through and secure with
4 x M8 Countersunk Bolts.
)
A
23
A) Align the holes on the Buttkicker Mount Pole with the T-Nuts previously installed in Step 22.
B) Bolt through and secure with 2 x M8 Bolts.
)
A
24
A) Align the front Seat Slider assembly with the T-Nuts previously installed in Step 01a & Step 01b.
B) Bolt through and secure with 2 x Ratchet Handles.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x Seat Sliders
• • 4 x Seat Slider
• • 4 x M8 Counter
End Plates
sunk Bolts
• • 4 x Sticky Felt Pads
(35mm x 40mm)
• • 6 x T-Nuts
PARTS:
)
B
• • 1 x Buttkicker Mount Pole
• • 2 x M8 16mm Bolt
• • 2 x M8 Washers
PARTS:
• • 2 x Seat Slider Ratchet Handles
Repeat
on Other
Side
Repeat
on Other
Side
)
B
17
Publicidad
