Publicidad
support@nextlevelracing.com
05
Slide 4 x T-Nuts into the bottom channels of the Base Assembly as shown.
06
Align the NLR Height Adjustable Feet with the
T-Nuts previously installed in Step 05.
Note: Foot alignment tab
should sit in the channel.
08
Align the tab on the NLR Height Adjustable Feet
with the channel on the bottom of the extrusions.
PARTS:
• • 4 x T-Nuts
• • 4 x Adjustable Feet
Note: Height of the foot can be adjusted only
when it's installed on to the cockpit.
07
Install the NLR Height Adjustable Feet into T-Nuts
previously installed in Step 05.
09
Tighten the Bolts inside the NLR Height Adjust-
able Feet with an Allen Key. Install Rubber Plug.
12
Note: Counterbore
holes facing outside
(R)
(L)
(L)
10
Align the threaded holes on the Wheel Post Connection Plates with the holes on the Wheel Posts.
Bolt through and secure using M8 Bolts and Washers.
(
)
FRONT
(
)
REAR
11
Align the Right Wheel Post Assembly with the T-Nuts previously installed in Step 01b.
Bolt through and secure with 4 x M8 Bolts and Washers.
(
)
FRONT
(
)
REAR
12
Align the Left Wheel Post assembly with the T-Nuts previously installed in Step 01a.
Bolt through and secure with 4 x M8 Bolts and Washers.
13
Video Instruction: bit.ly/nlrbuild
PARTS:
• • Wheel Post Connection Plates
• • 8 x M8 35mm Bolts
(R)
• • 8 x M8 Washers
• • 2 x Wheel Posts
PARTS:
• • 4 x M8 20mm Bolts
• • 4 x M8 Washers
PARTS:
• • 4 x M8 20mm Bolts
• • 4 x M8 Washers
Publicidad
