Publicidad
support@nextlevelracing.com
)
A
B
31
A) Align the Side Mount Brackets mounting holes with the threaded holes on the Front Mount Bracket.
B) Bolt through and secure with 2 x M8 Low Profile Bolts and Nylon Washers. Repeat on other side.
SIDE MOUNT ASSEMBLY
)
)
A
B
32
A) Align the mounting holes on the Spacer Plates with the mounting holes on the Wheel Base.
B) Bolt through and secure using 4 x M8 Countersunk Bolts.
Note: Use level provided to ensure
the Wheel Assembly is kept flat during
installation to avoid skewing.
33
Align the Side Mount Brackets mounting slots with the mounting slots on the Mounting Arms. Bolt
through and secure using 4 x M8 Low Profile Bolts, Nylon Washers and Flange Nuts.
20
PARTS:
• • Side Mount Brackets
)
• • 4 x M8 14mm Low Profile Bolts
• • 4 x M8 Nylon Washers
Repeat
on Other
Side
PARTS:
• • Spacers Plates
• • 4 x M8 20mm Countersunk Bolts
PARTS:
• • Side Mount Brackets
• • 4 x M8 25mm Low Profile Bolts
• • 4 x M8 Nylon Washers
• • 4 x M8 Flange Nuts
Note: Do not fully tighten the Bolts until the Wheel
Assembly is set in the desired position.
34
Align the mounting holes on the Wheel Base Assembly with the mounting holes on the Side Mount
Brackets. Bolt through and secure with 4 x M8 Low Profile Bolts and Nylon Washers.
SIDE MOUNT ANGLE ADJUSTMENT
35
Loosen the Bolts securing the Wheel Base Assembly to the Side Mount Brackets. Adjust to the desired
angle and tighten the Bolts to lock in place.
SIDE MOUNT BRACKET ADJUSTMENT
36
Loosen the Bolts securing the Side Mount Brackets to the Mounting Arms. Adjust to the desired
position and tighten the Bolts to lock in place.
21
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x M8 14mm Low Profile Bolts
• • 4 x M8 Nylon Washers
PARTS:
• • NIL
PARTS:
• • NIL
Publicidad
