Operating Instructions - auna TT-Play Prime Manual De Instrucciones

OPERATING INSTRUCTIONS

Unpacking the turntable
1. Carefully remove unit from its package and take it out of the plastic
bag.
2. Remove black tie-wrap by untwisting and gently
sliding out from under tone arm.
3. Remove white protective needle cover by gently
pulling towards front of unit.
Assembling the turntable
1. Very carefully centre the vertical bearing
ceramic shaft with the vertical bearing
opening on the bottom of the turntable
platter. Lower the platter onto the ceramic
shaft while keeping the platter parallel
with the top surface of the turntable.
2. Hold the belt on the circumference of the
platter from one of the vertical bearing
openings and then place the belt onto the
pulley of the motor.
3. Put the slip mat on the turntable platter,
lining up its centre hole with the centre
spindle.
4. Insert the speaker cable ends (exposed
wires) into the terminals located on the
back of the main unit to connect the
speakers with the turntable.
Connecting the AC power cord
After connecting the speakers unwind the AC power cord fully and connect
it to any convenient household 220 V~ 50 Hz AC outlet.
Turntable operation
Switch the unit on by turning the POWER SWITCH (9) located on the front
panel .
1. Set the SPEED SELECTOR (7) to desire speed (33 ⅓ or 45 rpm). Place
the record on the slip mat. For 45-rpm records, place the 45 rpm
adapter on the centre spindle before placing the record on the platter.
2. Remove the tie-wrap on the tonearm and unlock it. Push the lift lever
backward to raise the tonearm and gently move the tonearm towards
the desired position over the record. Lower the tone arm by moving
EN
19