Tonearm Counterweight Adjustment For Stylus Pressure - auna TT-Play Prime Manual De Instrucciones

TONEARM COUNTERWEIGHT ADJUSTMENT FOR
STYLUS PRESSURE
1. Remove the stylus protector from the cartridge and avoid touch the
stylus tip during the adjustment.
2. Release the tonearm hold down clip,
gently hold the tonearm and move it
away from the Tonearm Rest. At this
point, the tonearm is unbalance and free
to swing.
3. While gently holding the tonearm,
carefully rotate the Counterweight
towards the front of the turntable until the tonearm is horizontally
balanced and hovers freely just above the platter without the stylus
touching the platter surface.
4. Return the tonearm to the tonearm rest and lock the hold down clip.
5. While holding the counterweight steady without any rotation, rotate
carefully only the Downforce Scale Dial until the "0" on the scale lines
up with the centerline marked along the top of the tonearm.
6. Rotate the counterweight including the downforce scale dial couner-
clockwise (as seen from the front of the turntable) until the scale shows
the recommended pressure value for stylus.
Note: The recommended pressure for the factory-installed cartridge is 3.5g.
The cartridge only goes up to 2g. You will need to make one full rotation
and set it to 1.5 g to reach 3.5 g.
Pitch control
The turntable speed can be increased or decreased by approximately 10%
by rotating the pitch control knob. To increae the speed, turn the Pitch
Control knob clockwise. To decrease the speed, turn the knob counter-
clockwise.
EN
21