Fein CG13-150 Instrucciones De Uso página 22

en
22
Securing the workpiece (figure 8).
Secure the workpiece sufficiently. An
inadequately secured workpiece can,
for example, cause the grinding acces-
sory to jam. This can lead to kickback,
cause the workpiece to fall down, and
lead to other dangerous situations.
Dry grinding (figure 9).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the
power tool and move it over the sur-
face.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 10).
Always work in an up-grinding motion,
so that the cutting disc will not jump
out of the cut.
Fig. 8
Fig. 9
Fig. 10
2–1
1–1
3–1
2–1