Husqvarna 320iL Manual De Usuario página 11

2. Push the power trigger lockout (A) forward.
Make sure that it moves back to its initial
position when you release it.
3. Make sure that the power trigger and the
power trigger lockout moves freely and that
the return spring works correctly.
4. Start the product. Refer to
on page 15 .
5. Apply full power.
6. Release the power trigger lockout and make
sure that the cutting attachment stops fully.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment
guard. Always use the recommended
cutting attachment guard for the
cutting attachment that you use, see
Accessories on page 23 . If an
incorrect or faulty cutting attachment
guard is attached this can cause
serious personal injury.
The cutting attachment guard stops objects that
ejects in the direction of the operator. It also
1511 - 009 - 07.07.2022
A
To start the product
Do not use a cutting
prevents injuries that occur if you touch the
cutting attachment.
1. Stop the motor.
2. Do a visual check for damages, for example
cracks.
3. Replace the cutting attachment guard if it is
damaged.
Battery safety
WARNING:
instructions that follow before you use
the product.
• Only use an approved Husqvarna
rechargeable battery. Refer to
data on page 22 . The battery is software
encrypted.
• Use the Husqvarna battery that is
rechargeable as a power supply for the
related Husqvarna products only. To prevent
injury, do not use the battery as a power
supply for other devices.
• Risk of electrical shock. Do not connect the
battery terminals to keys, coins, screws or
other metal. This can cause a short circuit of
the battery.
• Do not use non-rechargeable batteries.
• Do not put objects into the air slots of the
battery.
• Keep the battery away from sunlight, heat
or open flame. The battery can cause burns
and/or chemical burns.
• Keep the battery away from microwaves and
high pressure.
• Do not try to disassemble or break the battery.
• If the battery leaks, do not let the liquid touch
your body or eyes. If you have touched the
liquid, clean the area with a large quantity of
water and soap, and get medical aid. If you
get liquid in your eyes, do not rub but flush
with water for a minimum of 15 minutes and
get medical aid.
Read the warning
Technical
11