Operation - Husqvarna 320iL Manual De Usuario

To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push and hold the lock button (A). Pull the
shafts apart.
To attach the cutting attachment guard
• Attach the cutting attachment guard (A) to the
shaft (C) with the screws (B).
B
C
Introduction
WARNING:
the safety chapter before you use the
product.
14
B
A
A

Operation

Read and understand
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery
charger to the wall. An electric
screwdriver can cause damage to the
battery charger.
1. Install the battery charger on the wall with
the 2 screws (B). Use wall plugs (A) if it is
necessary.
B
B
C
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger
and a mains socket.
Before you operate the product
• Examine the work area to make sure that you
know the type of terrain. Examine the slope of
the ground and if there are obstacles such as
stones, branches and ditches.
• Do a general inspection of the product.
Do not use an electric
A
D
1511 - 009 - 07.07.2022