Husqvarna 320iL Manual De Usuario página 8

• Faulty cutting attachment can increase the
risk of accidents.
• Do not allow children to use or be in the
vicinity of the product. Since the product is
easy to start, children may be able to start it if
they are not kept under full surveillance. This
can mean a risk of serious personal injury.
Disconnect the battery when the product is
not under close supervision.
• Ensure that no people or animals come closer
than 15 meters while you work. When several
operators are working in the same area the
safety distance should be at least 15 meters.
Otherwise there is a risk of serious personal
injury. Stop the product immediately if anyone
approaches. Never swing the product around
without first checking behind you to make sure
that no one is within the safety zone.
• Ensure that people, animals or other things
can not affect your control of the product
or that they do not come in contact with
the cutting attachment or loose objects that
are thrown out by the cutting attachment.
However, do not use the product unless you
are able to call for help in the event of an
accident.
• Always inspect the working area. Remove all
loose objects such as stones, broken glass,
nails, steel wire, string, etc., that could be
thrown out or become wrapped around the
cutting attachment.
• Make sure that you can move and stand
safely. Check the area around you for
possible obstacles (roots, rocks, branches,
ditches, etcetera) in case you have to move
suddenly. Take great care when you work on
sloping ground.
• Keep a good balance and a firm foothold at all
times. Do not overreach.
• Deactivate the product before you move to
another area.
• Never put the product down unless you have
deactivated it and removed the battery. Do
not leave the product unsupervised when it is
switched on.
• Remove the battery before you pass the
product to another person.
• Make sure that no clothes or parts of the body
come in contact with the cutting attachment
when the product is activated. Keep the
product below waist level.
8
• If anything jams in the cutting attachment
while you operate the product, stop and
deactivate the product. Make sure that the
cutting attachment stops completely. Remove
the battery before you clean, inspect or repair
the product and/or the cutting equipment.
There is a risk of burns as the gear housing
can become very hot. Use gloves when
working with the trimmer head.
• Keep your hands and feet away from
the cutting attachment until it has stopped
completely when the product is deactivated.
• Watch out for stumps of branches that can be
thrown out when you cut. Do not cut to close
to the ground where stones and other objects
can be thrown out.
• Watch out for thrown objects. Always wear
approved eye protection. Never lean over the
cutting attachment guard. Stones, rubbish,
etc., can be thrown up into the eyes which can
cause blindness or serious injury.
• Listen out for warning signals or shouts
when you wear hearing protection. Always
remove your hearing protection as soon as
the product stops.
• Never work from a ladder, stool or any other
raised position that is not fully secured.
• If any unwanted vibrations occur, tap out new
line to give the line the correct length to stop
the vibrations.
• Overexposure to vibration can lead to
circulatory damage or nerve damage in
persons who have poor circulation. Speak to
your physician if you experience symptoms
of overexposure to vibration. Such symptoms
include numbness, loss of feeling, tingling,
pricking, pain, loss of strength, changes in
skin color or condition. These symptoms
usually show in the fingers, hands or wrists.
• Always hold the product with both hands. Hold
the product on the right side of your body.
• Do not remove the cut material, or let
other persons remove cut material, while the
product is on or the cutting equipment rotates,
as this can result in serious injury.
• Always stop the product, remove the battery
and make sure that the cutting equipment
does not rotate before you remove unwanted
material that is wound around the shaft or
caught between the guard and the cutting
attachment.
1511 - 009 - 07.07.2022