Silvercrest SWKH 3100 A1 Manual De Instrucciones página 33

Cable rewind
An integrated cable rewind is located on
the underside of the base (7). You can
adapt the length of the power cable (6) to
the conditions at the location in which you
are using the kettle.
You can minimise the length of the cable
when you are not using the kettle.
•
Unwind the power cable (6) on the underside of the base (7).
•
Place the base (7) on a flat, non-slip and dry surface. Make sure that the power cable (6)
passes through one of the openings on the underside of the base (7). This is to ensure that the
kettle is positioned securely.
WARNING
If the power cable (6) does not pass through one of the openings on the
underside of the base (7), the base (7) and kettle (8) are not positioned
securely. The movement of the boiling water can make the kettle tip over and
cause serious damage to property and cause injuries!
•
Open the lid (1) by pressing the lid release button (2).
'Minimum filling' display
The minimum amount of water to be
filled is 0.5 l. This small amount can not
be displayed on the external water level
gauge (4).
For this reason, there is a special mark
inside the kettle (8) that precisely
displays the minimum filling amount
when you are filling in water. This mark
can be seen inside the kettle (8) when
the lid (1) is open.
•
Fill the kettle (8) with drinking water up to a minimum of the interior '0.5 l MIN' mark and a
maximum of the '1.7 l MAX' mark on the inside of the water level gauge (4) and shut the lid
(1).
You can freely rotate the kettle (8) by 360° around its vertical axis when you
place it on the base (7). The kettle does not need to be locked into a particular
position. This way, you can turn the kettle (8) so that the water level gauge (4)
is easy to see or to direct the steam from the kettle (8) away from you.
SilverCrest SWKH 3100 A1
English - 31