Residual Risks; Electrical Safety - Stanley SCS220 Traducción De Las Instrucciones Originales

ENGLISH

Residual risks

Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades
u
or accessories.
Injuries caused by prolonged use of a tool. When
u
using any tool for prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Labels on tool
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the
user must read the instruction manual before
use.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
18
(Original instructions)
Direct Current
n No-Load Speed
0
Class II
Construction
Earthing
Terminal
Safety Alert
Symbol
/min. Revolutions or
Reciprocation
per minute
Position of date code
The Date Code, which also includes the year of manufacture, is
printed into the housing.
Example:
2020 XX JN
Year of manufacturing
Additional safety instructions for batteries
and chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Chargers
Use your STANLEY charger only to charge the battery in
u
the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The charger is intended for indoor use only.
Read the instruction manual before use.
Do not attempt to charge damaged batteries.

Electrical safety

Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised STANLEY Service Centre
in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with
a regular mains plug.