Emos P5660SH Manual De Instrucciones página 7

8. The temperature value will start flashing; use the + and – buttons
to set the temperature of choice and confirm with TIME.
9. Repeat the process for the remaining temperature changes
(P3/4/5/6) in the day.
To end setting, wait 1 minute or press the MODE button.
Note: If you wish to delete a set programme, long-press the TIME
button when the time is flashing.
Move forward in settings by pressing the TIME button; pressing the
PROG navigates one step back in settings.
Manual Temperature Mode
Press the MODE button until SET and a temperature value appear
on the right of the screen.
Use the + and – buttons to set the temperature and wait 5 seconds
for the setting to automatically save.
The set temperature will be maintained until you cancel manual
mode.
Short-Term Manual Temperature Change
When in automatic mode, where temperature is controlled by the
selected programme, it is possible to make a short-term change to
the current temperature setting.
While in automatic temperature control mode (AUTO and P – pro-
gramme number displayed on the left side of the screen)
use the + and – buttons to set the new temperature and wait 5 se-
conds for the setting to automatically save.
P – programme number will disappear from the screen; AUTO will
remain.
The manually set temperature will be maintained until the pro-
grammed temperature change.
OFF Mode
Press the MODE button until OFF appears on the screen.
The room temperature and clock will be displayed, but current output
from the socket will be turned off.
To reactivate the socket, press MODE repeatedly to set the socket to
either the automatic or manual temperature control mode.
BOOST Mode
The BOOST feature can be used to heat up a room in a short time.
Press the BOOST button repeatedly to choose the time frame (30 min
to 9 hours, 30 min resolution).
Then, use the + and – buttons to choose temperature; the setting
will be saved automatically.
The chosen temperature will be valid for the entire set period.
The time and temperature remaining will flash on the screen along
with the room temperature and the clock.
Once the time elapses, the system will automatically switch back to
the previous temperature mode and the previously set temperature.
To end the BOOST function prematurely, use the MODE button to
select a different temperature mode or press the BOOST button
repeatedly until the time setting reaches 9 hours; the next press
will deactivate the BOOST function.
7