External Component Operations; Playing An External Component - JVC KD-DV5000 Manual De Instrucciones

EXTERNAL COMPONENT OPERATIONS

SRC
ATT
Operations of this section are explained using
the buttons on the control panel unless
mentioned otherwise.

Playing an external component

You can connect the external component to the
CD changer jack on the rear using the Line Input
Adapter KS-U57 (not supplied).
Preparation:
For connecting the Line Input Adapter KS-U57 and
the external component, refer to the Installation/
Connection Manual (separate volume).
Before operating the external component,
select the correct external input correctly by
following the procedure below.
• See also "Changing the general settings
(PSM)" on page 50.
1
Press and hold SEL (select) for more than
2 seconds so that one of the PSM items
appears on the display.
2
Press number button 5 to select "AUDIO"—
Audio category of the PSM settings.
Press ¢
3
or
Input"*.
4
Turn the control dial clockwise to select
"Line In."
5
Press SEL (select) to finish the setting.
• For details, see "To select the external
component to use—Ext Input" on page 53.
* Displayed only when one of the following sources is
selected—FM, AM, and CD.
SEL 1 2
4 to select "Ext
MODE
M
3 4 5 6
1
Select the external component
(LINE IN).
Each time you press the button,
the source changes as described
SRC
on page 8. When you select a
source, the power automatically
comes on.
* Displayed only when one of the following sources is
selected—FM, AM, and CD.
2
Turn on the connected component
and start playing the source.
3
Adjust the volume.
ATT
4
Adjust the sound characteristics
you want. (See pages 47 – 49.)
Note:
You can also change the display pattern by pressing
DISP (D) repeatedly.
DISP
D EQ
65