Keeping Data In Memory; Service And Repair; Service And Repair Contact; Accessories/Parts For The Product - HURNER Weld Control 315 2.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
is unplugged, a "Delete Memory" message appears. If the
START/SET key is pressed at this point, a further confirma-
tion message "Delete Memory, sure?" is shown, which has
to be confirmed once again by pressing the START/SET key.
Then, the report data in memory are deleted.
5.6

Keeping Data in Memory

When the cable or storage media is unplugged, a "Delete
Memory" message is displayed. Press the STOP/RESET key to
keep the current report data in memory. The process can
then be repeated once again.
Make a habit of handling the internal storage as descri-
bed at the beginning of Sect. 5, to maintain data inte-
grity and avoid any inadvertent deletion of the reports
Important
in memory.
6

Service and Repair

As the product is used in applications that are sensitive to
safety considerations, having it serviced and repaired only
by trained, specialized staff is highly recommended. Thus,
constantly high standards of operation quality and safety
are maintained. Feel free to request information on our
authorized service partner in your area at the address in
Sect. 7.
Non-compliance with this provision will dispense the
manufacturer from any warranty and liability claims for
the product and any consequential damage.
Important
7

Service and Repair Contact

HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specifica-
tions of the product without prior notice.
Info
8

Accessories/Parts for the Product

Facing Tool Blade for HÜRNER Weld Control 315 2.0
Only when genuine spare parts are used, liability
and warranty on the part of the manufacturer will
Info
Version May 2022
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER Weld Control 315 2.0 User's Manual 33
EN