Aligning The Appliance - Haier HC W9919FSGB Manual Del Usuario

EN

Aligning the appliance

The appliance should be placed on a solid, flat surface.
1. Tilt the appliance slightly backwards.
2. Set the feet to the desired level. Make sure the distance to the wall on the
hinge side is at least 100 mm to ensure that the door can open properly.
3. Check stability by alternately bumping diagonally; the slight swaying should be
the same in both directions. If this is not the case, the frame may be warped;
leaking door seals may result. A slight slope to the rear facilitates the closing
of the door.
Fine tuning of the doors
If the doors are not on a level, this mismatch can be remedied
as follows:
A) Using the adjustable foot
Rotate the adjustable foot in the direction of the arrows to
raise or lower the foot.
B) Using spacers
Open the upper door and lift it.
Carefully clip the spacer (enclosed in the accessory bag) in
the white plastic ring of the middle hinge, by hand or using
a tool such as pliers. Do not scratch or bruise the door.
Notice
During future use of refrigerator, the phenomenon of uneven doors may occur due to the weight
of the food stored; please adjust using the methods described above.
9. Installation
26