Mounting Preparations - Good Earth Lighting SE1289-BRS-02LF5-G Manual De Instrucciones

2
There are 2 methods to mount the fixture, wood
surfaces and masonry (see below).
Drill a 3/16 in. hole and place the masonry anchors in the pilot
holes. Hammer them into place until flush with the surface.
Drive long screws into masonry anchor until snug.
2a
There is an adjustable knob located directly below the light head. The light head can easily be
adjusted for WALL MOUNT, EAVE MOUNT, or DECK MOUNT.
Adjusting the light position
The adjustable knob on the arm operates the angle of the lamp
1
head. Adjust to wall, eave, or deck mount and then tighten.
Proceed to the installation steps below.

Mounting Preparations

3/16 (.19) in./6,4 mm
masonry bit
If mounting onto wood surface, drill 1/16 in. hole
and use the wood screws provided to secure the
mounting plate.
2b
2
Once the light is mounted, the light head can rotate a full 360°
to better direct light where needed. Once the direction has
been determined, tighten the knob to lock the light head into
place.
1/16 (.0625) in.
1,6 mm
5