Care & Maintenance - Ninja FOODI CI100 Serie Manual De Instrucciones

USING THE 700ML CHOPPER
(not included with all models)
IMPORTANT:
• Review all warnings before proceeding.
• The processing lid is NOT dishwasher safe.
NOTE:
• DO NOT add ingredients before completing installation of the blade assembly.
• DO NOT operate the chopper continuously for more than 15 seconds at a time.
• DO NOT fill past the MAX FILL line.
1 Place the chopper bowl on a clean, dry, level surface,
such as a worktop or table.
2 Exercising care, grasp the blade assembly by the top
of the shaft and place it onto the drive gear inside
the chopper bowl.
3
Add ingredients to the chopper bowl, then install the
processing lid so it sits into place. Ensure the lid is
fully installed prior to use; there will be no click.
6 When finished, unplug the unit. Remove the power
base from the chopper attachment by pressing and
holding the release buttons on either side of the
power base and lifting up.
7 Remove the lid by lifting it up. Always remove the
blade assembly before emptying ingredients from the
bowl by carefully grasping it by the top of the shaft
and lifting it out of the bowl.
8 DO NOT store blended contents with the blade
assembly and processing lid attached. Only use the
storage lid.
9 Refer to the Care & Maintenance section for cleaning
and storage instructions.
ninjakitchen.eu
4 Attach power base by aligning the arrow on the
power base with the arrow on the processing lid,
then push the power base onto the lid to lock it
in place. Plug the unit in.
5 Press and hold the
button to process. Use
short presses for short pulses and long presses
for long pulses. The TURBO button is disabled
when using the chopper attachment.
CARE & MAINTENANCE
WARNING: Handle the chopping blade with care when washing, as the blades are sharp.
Contact with the blade's edges can result in laceration.
CLEANING
• Hand-Washing
Wash hand blender attachment, beaters, dough hooks, chopper bowl, storage lid and blade assembly
in warm, soapy water. Use a dishwashing utensil with a handle to avoid direct contact with the
blades on the hand blender attachment and the chopping blades. Exercise care when handling blade
assemblies, as blades are sharp. Thoroughly rinse and air-dry all parts.
• Dishwasher
All attachments, with the exception of the power base, hand mixer attachment and the chopper
processing lid, are top-rack dishwasher safe.
• Motor Base, Hand Mixer Attachment, Chopper Processing Lid
Unplug the power base before cleaning. Wipe the power base, hand mixer attachment and chopper
processing lid with a clean, damp cloth. Do not submerge these parts in water.
• STORING
For cord storage, wrap the cord with the plastic clip.
RESETTING THE MOTOR
This unit features a safety system that prevents damage to the motor and drive system should you
inadvertently overload it. If the unit is overloaded, the motor will be temporarily disabled. Should this
occur, follow the reset procedure below.
1
Unplug the unit from the electrical socket.
2 Allow the unit to cool for approximately 15 minutes.
3 Remove the container's lid and blade assembly. Empty the container and ensure no ingredients are
jamming the blade assembly.
IMPORTANT: Ensure that maximum capacities are not exceeded. This is the most typical cause of
appliance overload.
ORDERING REPLACEMENT PARTS & ACCESSORIES
To order additional parts and attachments, visit ninjakitchen.eu.
Blending Jug:
Large jug perfectly designed for the hand blender attachment
to blend your favourite recipes.
ninjakitchen.eu