Taurus 913600A Manual De Instrucciones página 6

3.2.4.3. Following their sequence shown in the
picture, assemble the worm shaft blade and
cutting disc into the Cutting meat canister, then
assemble the cutting screw bar into the Cutting
meat canister clockwise.
3.2.4.4. Following their sequence shown in the
picture, assemble the worm shaft, Conductor and
meatball canister into the Cutting meat canister
then assemble the cutting screw bar into the
Cutting meat canister clockwise.
WARNING: Please remember to disassemble the
cutting cylinder from the machine, when changing
these accessories.
3.2.4.5. Following their sequence shown in the
picture, assemble the Worm shaft, Lead cover and
sausage canister into the cutting meat canister
then assemble the cutting screw bar into the
cutting meat canister clockwise.
3.2.4.6. Tilt the assembled prepared cutting
cylinder about 45 degrees to the right. Align
the gear to the receiver and push inwards while
turning the assembled prepared cutting cylinder
counter clockwise until it locks in the upward
position as illustrated in the image below.
Dough Beater
OPEN
OFF
1
2
3
4
5
6
7
8
Whisk
3.2.4.7. Assemble the loading tray into the cutting
meat canister then place a bowl at the outlet of the
cutting meat canister.
3.2.4.8. Turn switch to the appropriate speed then
put food into the feeding inlet with the food pusher
to push the food down.
3.2.4.9. Turn switch to "OFF" when the food is
ready then unplug and cut off power. Remove
pusher and loading tray.
3.2.4.10. Turn the meat canister about 45 degrees
clockwise to remove it from the machine.
Dough Beater Whisk
3.2.4.11. Assemble the front protection cover
downwards. Do not use other functions when
using the meat grinder.
Dough Beater Whisk
3.2.5. Using the blender attachment
3.2.5.1. Open the safety cover. Do not use other
functions when using the blender.
Dough Beater Whisk
OPEN
OFF 1
2
3
4
5
6
8 7
OPEN
OFF
1
2
3
4
5
6
7
8
OPEN
OFF
1
2
3
4
5
6
7
8