SOMFY Sonesse 30 DCT Manual De Instrucciones página 8

EN
2.1.5.Installing the drive-tube assembly
CAUTION
• The motorised product must not be compressed between the brackets.
• Do not use the plastic cross without the metal bracket adapter.
▪ The drive can be fixed directly onto the drive bracket (the screw holes are
spaced 29 mm apart). Use 2 screws (3.5 x 9 mm). A manual tightening torque of
1 Nm is recommended.
▪ Drive plates are also available in the current
catalogue (Select the correct drive plate
adapted to the bracket and check the
torque requirements in the system). Use
the 2 screws (3 x 6 mm) delivered with the
motor plate. A manual tightening torque of
0,3 Nm is recommended.
1] Screw the bracket adapter to the drive
head.
2] Install and fix the drive-tube assembly
onto the end bracket (c) and onto the
drive bracket (d).
CAUTION
• Do not let the tube hanging by the head side only.
• Ensure that the drive-tube assembly is secured onto the end bracket. This
operation prevents the tube-drive assembly from coming out of the end
bracket attachment.
• Light gap reduced: Do not pinch cable or be careful they are not in contact
with moving parts.
8
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Sonesse 30 DCT
d
c