Commissioning; Checking The Direction Of Rotation; Setting The End Limits - SOMFY Sonesse 30 DCT Manual De Instrucciones

Sonesse 30 DCT
2.3.2.4.Correspondence

2.4.Commissioning

NOTICE
Orange LED blinks continuously in setting mode.

2.4.1.Checking the direction of rotation

Press the Up button on the setting tool:
a] If the motorised product rises, the direction of
rotation is correct: move onto Setting the end
limits [} 11].
b] If the motorised product lowers, the direction
of rotation is incorrect: move onto the next step.
b1] Press the Stop button on the setting tool until
the motorised product moves up and down: the
direction of rotation has been modified and green
LED blinks 5 times.
b2] Press the Up button on the setting tool to
check the direction of rotation.

2.4.2.Setting the end limits

NOTICE
The end limits can be set in any order.
NOTICE
With the setting tool, it is possible to cancel and exit the end limits setting mode
by simultaneously pressing the Up, Stop and Down buttons. This mode is also
cancelled with inactivity of 2 minutes.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
ST OP ST OP
a
b
b1]
ST OP
]
]
b2]
EN
11