GRAPHTEC CE7000 Serie Manual De Configuración página 4

Connection to computer
Make a connection between the cutting plotter and the
computer using your interface cable. The available interface
is USB/Network/RS-232C (It depends on the sales area.).
* Please install driver before connecting.
RS-232C cable (commercially available product)
(9-pin female - 9-pin female straight connected cable)
Network (LAN) cable
(Commercially available product)
USB cable (Accessories)
Preparation of cutter plunger
Set the cutter blade in the cutter plunger and then use it with
the cutter plotter. Set the cutter blade in the cutter plunger
according to the instruction manual supplied with the cutter
plunger.
Adjusting the blade length
Refer to the instruction manual supplied with the cutter
plunger and adjust the blade length according to the media.
When a general cutting sheet is used, the blade length that is
shorter than the combined thickness of film and backing
sheet and longer than the thickness of film is optimal. When
using the thin media such as a film, adjust the blade length
using the supplied loupe. (Refer to User's Manual.)
Film
Backing Sheet
Attaching a Tool
Loosen the screw of the tool holder and push the tool
(plunger) completely until it touches the top surface of tool
holder while pushing up the tool holder up. Make sure that
the bracket (gray) is engaged on the tool's flange, and then
tighten the screw.
Bracket to hold tool
Tool holder
(Forward: Using cutting)
Bracket to hold tool
Optimal blade length
Film thickness
Flange Tool holder
Tool holder
(Backward: Half
cutting/Plotting Pen)
Flange
Aligning the push roller
Lower the media set lever to raise the push rollers. Adjust the
left and right push roller positions according to the width of
the media. Use the roller position guide to place the push
rollers on both ends of the media and the right push roller on
the rightmost wide grit roller.
Media set lever
Grit roller
For models with Four or more push rollers, place the push
rollers other than both ends on the grit roller.
<Example of model with four push rollers>
Media sensor
Push roller's hold-down force
In models with a push roller's hold-down force switching
mechanism, make the left and right push roller's hold-down
force equal.
For details on the each push roller's force setting, refer to the
instruction manual. (CE7000-130/CE7000-160 only)
Low
Hold-down force Hold-down force
When narrow media (160 mm or less) is used
Use the rightmost wide grit roller to set the media on the
media sensor.
Grit roller
Media sensor
On CE7000-130/160, use the two push rollers on the right
side and set "MENU" - "ADVANCE" - "MEDIA WIDTH" to
"NARROW".
Set the third and subsequent push rollers to Low hold-down
force, and do not place them on the grit roller.
<Example of model with four push rollers>
Media sensor
Push roller
position guide
Push roller
Push rollers
Media
Grit roller
Medium Strong
Hold-down force
Push rollers
Media
Push rollers
Media
Grit roller