Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope.
Never stand directly below the device when mounting, removing or servicing the fixture.

DMX CONNECTION

Connect an XLR cable to the male 3-pin XLR output of your controller and the other side to the fe-
male 3-pin XLR input of the light.You can chain multiple lights together through serial linking
The cable needed should be two core, screened cable with XLR input and output connectors.
DATA CABLING
To link fixtures together you must use data cables. If you choose to create your own cable, please
use data-grade cables that can carry a high quality signal and are less prone to electromagnetic
interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female
XLR connector on the other end.
Termination reduces signal errors. To avoid signal transmission
problems and interference, it is always advisable to connect a DMX
signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chas-
sis ground. Grounding the common can cause a ground loop, and
your fixture may perform erratically. Test cables with an ohm meter to check correct polarity and
to make sure the pins are not grounded or shorted to the shield or each other.
DMX MODE SETTING:
When the fixture is in DMX status, you can connect several machines via the signal cable, without
the use of a DMX controller. This is the Master/slave mode. You set up the mode on the first fixture
and the other fixtures will follow the master automatically.
If the fixture is connected to a DMX controller, the signal will be sent from the controller and you
can control the fixture via DMX.
MENU MAP
The fixture has an LCD display with 4 buttons on the rear panel. Press MENU to choose different
functions, press UP/DOWN to modify the value, press ENTER to confirm.
www.afx-light.com
3
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

16-2803

Tabla de contenido