Metabo HPT C 7UR Instrucciones De Manejo página 10

Ocultar thumbs Ver también para C 7UR:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
C7UR : Circular Saw
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always wear hearing protection.
V
Rated voltage
Cutting depth
P
Power Input
n
No-Load speed
0
Weight (without cord)
kg
Switching ON
Switching OFF
Disconnect mains plug from electrical outlet
Blower
Prohibited action
Class II tool
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
○ Saw Blade (Dia. 185 mm) (mounted on tool) ................1
○ Hex. Bar wrench (mounted on tool)...............................1
○ Guide ............................................................................1
○ Wing-bolt ......................................................................1
○ Lock Spring ...................................................................1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES
○ Lever (short type) ..........................................................1
○ Dust collector ................................................................1
APPLICATIONS
Cutting various types of wood.
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 17.
NOTE
Due to metabo HPT's continuing program of research
and development, the specifi cations herein are subject
to change without prior notice.
MOUNTING AND OPERATION
Action
Adjusting the cutting depth
Adjusting the angle of inclination
(0o – 45o)
Adjusting the angle of inclination
(45o – 55o)
Regulating the guide
Cutting line
Using the cord holder
Mounting the dust collector set
(optional accessory)
Switch operation
*1
Dismounting the saw blade
Cutting (Do not use the tool with
only the blower function.)
Mounting the Saw Blade
Adjusting the base and saw blade
to maintain perpendicularity
Selecting accessories
*1 Before beginning work, check to ensure that operating
the switch correctly turns the tool ON and OFF.
While the tool is plugged in to the receptacle, ensure that
the sawblade stops when the switch is turned OFF.
MAINTENANCE AND INSPECTION
1. Inspecting the saw blade
Since use of as dull saw blade will degrade effi ciency
and cause possible motor malfunction, sharpen or
replace the saw blade as soon as abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Inspecting the carbon brushes (Fig. 15)
The motor employs carbon brushes which are consumable
parts. Since an excessively worn carbon brush can result
in motor trouble, replace the carbon brushes with new
ones having the same carbon brush No. ⓐ shown in the
fi gure when it becomes worn to or near the "wear limit" ⓑ.
In addition, always keep carbon brushes clean and ensue
that they slide freely within the brush holders.
CAUTION
When replacing the new carbon brushes, always use
genuine metabo HPT carbon brushes with the number
specifi ed in the drawing.
4. Replacing carbon brushes (Fig. 15)
Disassemble the brush caps with a slotted-head
screwdriver. The carbon brushes can then be easily
removed.
10
Figure
Page
2
3
2
4
2
5
3
6
3
7
3
8
3
9
3
10
4
11
4
12
5
13
5
14
18

Publicidad

Tabla de contenido
loading

Tabla de contenido