Proper Handling; Electronic Controller - Rupes HQM83 Manual De Instrucciones

may grab the surface and pull the power tool out of your control.
• After changing the bits or making any adjustments, make sure the collet nut, chuck or any other
adjustment devices are securely tightened. Loose adjustment devices can unexpectedly shift, causing loss
of control, loose rotating components will be violently thrown.
• Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could
snag your clothing, pulling the accessory into your body.
• Regularly clean the power tool's air vents. The motors fan will draw the dust inside the housing and excessive
accumulation of powdered metal may cause electrical hazards.
• Do not operate the power tool near fl ammable materials. Sparks could ignite these materials.
• Do not use accessories that require liquid coolants. Using water or other liquid coolants may result in
electrocution o shock.

PROPER HANDLING

The tool is designed for as a one handed control operation for sanding operations.
PARTS OF THE TOOL
1 - Identifi cation plate.
2 - ON/OFF / speed regulation Knob.
3 - Abrasive sheet (not supplied).
4 - Velcro faced swallow backing pad for orbital
movement.
5 - Motor ventilation slots.
6 - Magnetic fl ange.
7 - ON/OFF switch lever.
MOTOR
WARNING: To reduce the risk of injury, only the Li-ION Battery Pack 9HB125LT (8) or the Power
supply 9HP120LT (10) (optional) for the motor supply should be used with this product.
The tool is operated by a DC motor. Since the batteries, other than those offered by Rupes, have not been tested
with this product, use of such batteries with this tool could cause the injury and property damage.
SWITCH
WARNING: To reduce the risk of injury, turn the knob (2) until OFF position after any use.
To turn the unit on, rotate the potentiometer knob (2) and set up the speed from 1 to 5 value. Push the switch lever
(7) towards the body of the tool.
To turn it off, release the lever and rotate the potentiometer knob until OFF position.
MAGNETS
WARNING: Magnets produce a far-reaching, strong magnetic fi eld.
They could damage tvs and laptops, computer hard drives, credit and atm cards, data storage media, mechanical
watches, hearing aids and speakers. Keep magnets away from devices and objects that could be damaged by
strong magnetic fi elds.
WARNING: It contains magnets. Magnets could affect the functioning of pacemakers and implanted
heart defi brillators. Please avoid contacts with the tool if you or someone near you has a Pacemaker.
Avoid damage of the Pacemaker.
- A pacemaker could switch into test mode and cause illness.
- A heart defi brillator may stop working.
- If you wear these devices keep suffi cient distance to magnets.
- Warn others who wear these devices from getting too close to magnets.
Magnets are contained into the fl ange (6), into the backing pads (4, 13) and into the DC motor.

ELECTRONIC CONTROLLER

The main functions of electronic controller are: Speed control, Batteries and motor protection, Battery pack
level indication.
8
8 - Battery pack 10,8V cod. 9HB125LT.
9 - Battery level LED.
10 - Power supply cod. 9HP120LT (optional).
11 - Hexagonal shaft to attach magnetic backing
pads.
12 - Functional Unit ø2 mm orbit.
13 - Velcro faced round backing pad for random
orbital movement.