Maintenance And Servicing - Rupes HQM83 Manual De Instrucciones

1) the machine is used with a battery – assure that the battery pack is charged (see Battery pack level indication
(9)); assure the battery was inserted correctly;
2) the machine is used with a power supply – check to make sure the prongs on the cord plug are making
good contact in the outlet; check if the current is present in the plug. Also, check for blown fuses or open circuit
breakers in the line.

MAINTENANCE AND SERVICING

WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source (when
machine is connected to a power supply) or battery pack (when machine is connected to a battery
pack) before installing and removing accessories, before adjusting or when making repairs. Be sure
the switch is in the "OFF" position. An accidental start-up can cause injury.
CLEANING
WARNING: Regularly clean the magnetic attach in the backing pad and the magnetic fl ange. The
orbital movement and the backing pad position are guaranteed without the presence of metallic
powder. At the end of each work session, or when required, remove any dust from the body of the tool using
a soft cloth, paying particular attention to the motor ventilation slots.
LUBRICATION
This tool has been lubricated with a suffi cient amount of high grade lubricant for the life of the unit under normal
operating conditions. No further lubrication is necessary.
REPAIRS
Maintenance and cleaning of the inner parts like ball bearings, gears etc. or others, must be carried out only by an
authorized customer service workshop.
WARRANTY
Complying with current applicable regulations and subject to more favorable conditions that could apply in different
countries, RUPES professional tools are supplied with a 12 months warranty against manufacturing defects from
date of purchase. Only RUPES original parts and accessories must be employed with RUPES tools. RUPES is
not responsible for any damages or accidents caused by not abiding to this rule and the warranty shall terminate
if non-original parts are employed.
Damages caused by natural wear and tear, overloading, faulty maintenance and tool usage differing from the one
specifi ed in the user guide, are not covered by this warranty. A tool which has been proven faulty must be delivered
to an authorized.
RUPES service center along with its fully fi lled out warranty certifi cation and document of purchase. Warranty shall
be void if tool should be delivered disassembled or tampered.
This warranty does not in any way imply tool's replacement.
RUPES SpA reserves the right to make specifi cations or design changes to its products without further notice.
RUPES does not accept any responsibility for any possible printing mistake. This document supersedes all
previously printed one.
FREE LABEL REPLACEMENT: If your labels become illegible or are missing, cal 0039 02 94 694 1 RUPES spa
for a free replacement..
Rupes Q-MAG NANO iBrid tool Part Numbers:
HQM83 – Short neck Rupes Q-MAG NANO iBrid tool
HQM83L – Long neck Rupes Q-MAG NANO iBrid tool
9HC120LT – Li-ION Battery Charger
9HB125LT – Li-ION Battery pack
9HP120LT – Rupes NANO iBrid tool Power Supply
Vermezzo (MI), 2020/09/10
Via Marconi, 3A - Loc. Vermezzo
20071 - VERMEZZO CON ZELO (MI) - Italy
The President
G. Valentini
Technical fi le at:
RUPES SpA
S.p.A.
11