Hanging The Fan - Kichler 56 Brahm LED Manual De Instrucciones

HANGING THE FAN

REMEMBER to turn o the power before you begin installation. This is necessary for
your safety and also the proper programming of the control system.
To properly install your ceiling fan, follow the steps below.
Step 1. Before attaching fan to outlet box (not included), ensure the outlet box is securely
fastened to at least two points to a structural ceiling member (a loose box will cause the
fan to wobble). Pass the 120 volt supply wires from the ceiling outlet box through the
center of the ceiling mounting bracket. Install mounting bracket to outlet box in ceiling
using the screws and washers included with the outlet box. (Fig. 5)
Step 2. Remove the hairpin and clevis pin from the downrod assembly, retain for later use.
Remove the hanger ball from the downrod assembly by loosening set screw, removing
NOTE: Make sure to keep loosened hardware separate to avoid confusion during
installation.
Step 3. Loosen the two set screws on the motor coupling. (Fig. 7)
Outlet Box
Ceiling Mounting Bracket
Flat Washer
Screw
Fig. 5
Hanger Ball
Set Screw
Cross Pin
Clevis Pin
Hairpin
Fig. 6
Set Screw
Motor Body
Fig. 7
56"/ 48" Brahm LED | 7