Installing The Light Kit And Glass - Kichler 56 Brahm LED Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING THE LIGHT KIT AND GLASS

CAUTION:
Before continuing installation, confirm that the power is still turned
o at the main circuit breaker or by removing the circuit fuse. Turning the power
o using a wall switch is not su cient to prevent electrical shock.
Step 1. Hold the light kit close to the switch housing and connect the WHITE
wires from the light kit and fan by pushing the connectors together. Follow the
Light Kit
same procedure with the BLACK wires. (Fig. 20)
Step 2. Tuck the connections neatly into the light kit. Remove one of three
screws pre-installed on the switch housing and keep for later use. Loosen the
Fig. 20
other 2 screws (do not remove). Place the two slot holes on the light kit over
the 2 screws previously loosened from the switch housing. Rotate the light kit
until it locks in place at the narrow end of the key holes. Secure by tightening
the 2 screws previously loosened and the one previously removed. (Fig. 20)
Step 3. Secure the glass to switch housing by twisting in a clockwise direction,
twist the glass gradually until it snaps on to the switch housing. Do not over -
tighten. (Fig. 21)
Glass
Fig. 21
14 | KICHLER.COM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

48 brahm led300044300048

Tabla de contenido