Transmitter; Operating Instructions - Kichler 56 Brahm LED Manual De Instrucciones

INSTALLING AND REMOVING THE HANDHELD TRANSMITTER
Step 1. To place the transmitter in the wall plate, put the bottom end in first and
then press the top into the wall plate. The transmitter is now held in the wall plate
and will function from here. (Fig.24)
Step 2. To remove the transmitter from the wall plate, push the release button
and the transmitter will fall into your hand.

OPERATING INSTRUCTIONS

WARNING: Chemical Burn Hazard. Keep batteries away from children.
Step 1. Using a screwdriver, remove the battery cover from the handset and save
the screw for later use. (Fig. 25)
Step 2. To make fan operational, install two 3V CR2032 batteries (included). The
batteries should be installed with the positive (+) side up. Replace with CR2032
batteries when necessary. (Fig. 26)
NOTE: If not used for long periods of time, remove batteries to prevent damage
to the handset control. Store the control away from excessive heat or humidity.
16 | KICHLER.COM
Fig. 24
Fig. 25
Batteries
Batteries
Fig. 26