Roborock Q7+ Manual Del Usuario página 14

FAQs
Problem
Red LED indicator on
the Auto-Empty Dock
Reduced emptying
performance or unusual noise
when emptying
Auto-emptying does not start when
the robot returns to the dock
The robot cannot return to the
dock or cannot be charged
Solution
• The dustbin cover is not in place. Check and correct installation.
• The fan is not operating properly. Potentially due to overheating protection resulting
from frequent starting and stopping. Unplug the power cable and try again after 30
minutes.
• Voltage error. Check that local voltage meets the requirements listed on the dock.
• The main brush or main brush cover is not properly installed. Check and correct
installation.
• The filter, air duct, suction inlet, air inlet, or dustbin is blocked. Clean to remove
blockages.
• Auto-emptying is disabled. Check in-app settings.
• Dustbin cover is not in place. Check and install.
• Auto-emptying will not be triggered if the robot is moved to the dock manually. Start
emptying manually.
• Auto-emptying will not be triggered if the robot returns to the dock without cleaning.
• The robot will not auto-empty after returning to the dock in Do Not Disturb (DND)
mode. Adjust cleaning or DND duration, or start emptying manually.
• The battery level is lower than 10%. Charge the robot until the battery reaches 10%.
• The dock is surrounded by obstacles. Clear any obstacles around it or move it to an
open area as recommended in the User Manual.
• The dock is not connected to a power supply. Make sure the power cable is securely
plugged in and power is on.
• Poor contact. Clean charging contacts.
14