Menu Level 4: Default Setting; Menu Level 5: Temperature Unit Display - Dometic WAECO CoolAir CA850S Instrucciones De Instalación

CoolAir
➤ Press the Operating Mode button (fig. 6 on page 5, item 4) to con-
firm your entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 3 again and can use the + and – buttons to
switch between menu levels.
6.3.5

Menu level 4: Default setting

You can reset the parameters you set in configuration mode on menu
levels 1 to 3 to the default settings:
➤ Start configuration mode (see Chapter "Starting and ending configu-
ration mode" on page 33).
✓ The first digit of the display (fig. 6 on page 5, item 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + button (fig. 6 on page 5, item 6) three times to switch to
menu level 4.
✓ The digital display shows
➤ Press the Operating Mode button(fig. 6 on page 5, item 4), to reset
the unit to the factory settings.
✓
flashes in the digital display.
--
➤ Press the + button.
✓ The digital display shows
➤ Press the Operating Mode button (fig. 6 on page 5, 4) to confirm
your entry.
✓ The parameters set in configuration mode are reset to the default set-
ting.
✓ You are now in menu level 4 and can use the + and – buttons to switch
between menu levels.
6.3.6

Menu level 5: Temperature unit display

The system can display the room temperature in °C or °F. This parameter
can be configured:
➤ Start configuration mode (see Chapter "Starting and ending configu-
ration mode" on page 33).
✓ The first digit of the display (fig. 6 on page 5, item 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + (fig. 6 on page 5, item 6) four times to switch to menu lev-
el 5.
36
.
--
.
00
Installation