Connect Signal And Power Cables - Airwell HDHC-025N-09M25 Manual De Usuario E Instalacion

Step 6: Connect signal and power cables
The signal cable enables communication between
the indoor and outdoor units. You must first choose
the right cable size before preparing it for connection.
Cable Types
Indoor Power Cabl (if applicable):
•
H05VV-F or H05V2V2-F
Outdoor Power Cable: H07RN-F or H05RN-F
•
Signal Cable: H07RN-F
•
Models
N
L
Power supply cable
N
L
Connection cable
W
S
1. Open and x the position of the panel,
then, open the covers of the two lock
blocks, unscrew the screw , then hold
both sides of the lower panel in the place
marked "PULL", pull it upwards to release
the buckles, then take the lower panel
down(please refer to Page 22-23).
2. Open the wire box cover to connect the cable.
Unscrew the cable clamp below the terminal
3.
block and place it to the side.
Facing the back of the unit, remove the plastic
4.
panel on the bottom left-hand side.
9k
12k 18k
Nominal sectional area
1.5mm 2
1.5mm 2
2
2.5mm 2.5mm
1.5mm 2
1.5mm 2
2
2.5mm 2.5mm
1.5mm 1.5mm
2 2 2
2.5mm 2.5mm
2 2
2
1.5mm
1.5mm 1.5mm 2.5mm
2 2 2
1.5mm
1.5mm 1.5mm 2.5mm
2
2 2
1.5mm
1.5mm 1.5mm
2.5mm
2
2 2
1.5mm 1.5mm 1.5mm
2.5mm
2 2 2
1.5mm
1.5mm 1.5mm 2.5mm
WARNING
ALL WIRING MUST BE PERFORMED
STRICTLY IN ACCORDANCE WITH THE
WIRING DIAGRAM LOCATED ON THE
BACK OF THE INDOOR UNIT S FRONT
PANEL .
5. Feed the signal wire through this slot, from
the back of the unit to the front.
24k
6. Facing the front of the unit, connect the wire
according to the indoor unit's wiring diagram,
2
connect the u-lug and rmly screw each wire
2
to its corresponding terminal.
2
2
2
2
2
2
First open the front panel, then remove
the lower panel.
Rat baffle(some units)
Knock-out
panel
NOTE: If the size of the cable is too big, remove
the middle small plastic knock-out panel to create
a slot through which the cable can exit. If you want
to remove the chassis or drain hose, please remove
the rat ba e rst.
'
open the
Wire cover
Terminal
block
Cable
clamp
Page 25
 