Mounting Dimensions - Airwell HDHC-025N-09M25 Manual De Usuario E Instalacion

Outdoor Unit Dimensions (mm)
Models
805x554x330 (31.7"x 21.8"x 12.9")
YDAC-025R-09M25
805x554x330 (31.7"x 21.8"x 12.9")
YDAC-035R-09M25
890x673x342 (35.0"x 26.5"x 13.5")
YDAC-050R-09M25
890x673x342 (35.0"x 26.5"x 13.5")
YDAC-070R-09M25
If you will install the unit on the ground or
on a concrete mounting platform, do the
following:
1. Mark the positions for four expansion bolts
based on dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Place a nut on the end of each expansion bolt.
4 . Hammer expansion bolts into the pre-drilled
holes.
5. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
6. Put washer on each expansion bolt, then
replace the nuts.
7. Using a wrench, tighten each nut until snug.
WARNING
WHEN DRILLING INTO CONCRETE, EYE
PROTECTION IS RECOMMENDED AT ALL
TIMES.
W x H x D
If you will install the unit on a wall-mounted
bracket , do the following:
1.Mark the position of bracket holes based on
dimensions chart.
2. Pre-drill the holes for the expansion bolts.
3. Place a washer and nut on the end of each
4. Thread expansion bolts through holes in
5. Check that the mounting brackets are level.
6. Carefully lift unit and place its mounting feet
7. Bolt the unit firmly to the brackets.
8. If allowed, install the unit with rubber
gaskets to reduce vibrations and noise.

Mounting Dimensions

Distance A (mm)
511 (20.1")
511 (20.1")
663 (26.1")
663 (26.1")
CAUTION
Make sure that the wall is made of solid brick,
concrete, or of similarly strong material. The
wall must be able to support at least four
times the weight of the unit.
expansion bolt.
mounting brackets, put mounting brackets
in position, and hammer expansion bolts into
the wall.
on brackets.
Distance B (mm)
317 (12.5")
317 (12.5")
354 (13.9")
354 (13.9")
Page 29
 