6. Now attach the power supply to the first base.
DECLARATION OF CONFORMITY
This product meets the requirements of
European Directives
2006/95/CE and 2004/108/CE.
SPECIFICATIONS
100-240 V ~ 50/60 Hz
max. 10 bases
type light bulb: 2 x LED light bulb Sticks
Rubberwood bases cannot be used outdoors or in
wet areas!!
IP65
REPLACING A LED LIGHT BULB
1. Make sure that all the bases are disconnected from the electricity network!
2. Turn over the base and disconnect the faulty LED light bulb.
3. Remove the faulty light bulb from the topside of the base, if necessary by pushing from below. Insert a new
EXTREMIS LED light bulb.
4. Connect the LED light bulbs as explained on the previous page.
7. Then turn the bases over and position them where
you want them. Finally, place the rods into the holes
provided in the base
:
The supplied plug (part of SD) is a Europlug (Type E). In
countries where this plug is not used, please provide a
suitable plug yourself.
english
9