BABYTREND HC01 A Serie Manual De Instrucciones página 6

ASSEMBLY
WARNING:
Always check that the high chair is locked
in the open position before using.
WARNING:
The tray is not designed to hold the child
in the chair. The child should be secured in the high chair
at all times by the 5-point restraining system, either in the
reclining, semi-reclining or upright position.
TO ATTACH TRAY
10) • To attach the Tray, line up the grooves on
the bottom of the tray with the armrests
of the high chair. Squeeze the Tray's
release handle and slide the tray onto
the armrests (Fig. 10a). The Tray has
a 3-position adjustment. To adjust the
position, squeeze the Tray's release
handle located underneath the tray and
reposition the tray to the desired position
(Fig. 10b). Release the Tray's handle.
Check that the Tray is securely locked in
its new position.
TO ATTACH TRAY INSERT
11) • The dishwasher safe food Tray Insert
snaps onto the High Chair Tray and is
held in place by tabs on the sides of the
Tray. When installing the Tray Insert
make sure that its snaps into place to
prevent the child from removing the Tray
Insert. To remove Insert, unsnap the tabs
from the Tray.
• The Tray may be stored on the back legs
of the High Chair. Align the holes in the
rear of the tray with the small pegs on the
back legs (Fig. 11).
9
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Tray Release located underneath tray
Fig. 10a
3-position
Fig. 10b
Fig. 11
TO USE SAFETY BELT
WARNING:
It is
recommended that only
children capable of sitting
upright unassisted use the high
chair in the upright position.
WARNING:
Prevent
serious injury or death from
falls or sliding out. Always use
the restraint system. The child
should be secured in the high
chair at all times by the 5-point
restraining system, either in
the reclining, semi-reclining or
upright position.
The Tray is not designed to hold the child in
the chair. Stay near and watch child during
use. NEVER leave child unattended.
12) • The shoulder straps of the 5-point
harness have 2 attachment positions.
Select the position that places the
shoulder strap level with, or below, the
top of the child's shoulder (Fig. 12a).
• Carefully place the child in the seat and
position the safety harness around the
child's waist and over the shoulders.
Place the crotch strap between the
child's legs. Insert the male end of each
shoulder/waist belt into the buckle on the
crotch strap. Tighten the harness to be
snug around the child's waist and over
the child's shoulders (Fig. 12b).
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 12a
Adjust for a snug fit
Fig. 12b
10