VALBERG 3S58 F WAD929C Instrucciones De Uso página 25

B
The Display window shows the state of the dishwasher:
a) Display window shows "-:--" -----------------------> stand by;
b) Display window shows "H:MM" and not blinking ---> pause;
c) Display window shows "H:MM" and blinking -------> run;
d) Display window shows "END" ----------------------> end.
NOTE
If you open the door during washing, the machine will pause.
When you and press the Start/Pause Button, the machine
will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the selected
program after the power cut.
Forget to add a dish?
A forgotten dish can be added only when the detergent. If this is the case, follow the
instructions below:
1. Press the Start/Pause button to pause the running program.
2. Open the door.
3. Add forgotten dishes.
4. Close the door.
5. Press the Start/Pause button, the dishwasher will continue to run.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds, then
stop. Turn off the appliance using the ON/OFF button, shut off the water supply and open
the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid
scald, the dishes and utensils are still hot and more susceptible to breakage. They will
also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the Power button.
2.Turn off the water tap.
Using the appliance
23 EN