VALBERG 3S58 F WAD929C Instrucciones De Uso página 16

B
C. Place the end of the funnel (if supplied) into the hole and introduce about, 0.13kg of salt.
It is normal for a small amount of water to come out of the salt container.
D. After filling the container, screw the cap tightly back clockwise.
E. Usually, the salt warning light will be cease to be illuminated within 2-6 days after the
salt container has been filled with salt.
F. Immediately after filling the salt into the salt container, a washing programme should be
started (Suggest choose rapid program). Otherwise filter system, pump or other important
parts of the machine may be damaged by salty water. It is out of warranty.
NOTE
• The salt container must only be refilled when the salt
warning light in the control panel comes on. Depending on
how fully the salt dissolves, the salt warning light may still
be on even though the salt container is filled. If there is no
salt warning light in the control panel (For some Models),
you can judge when to load the salt into the softener by
the cycles that the dishwasher had run.
• If there are spills of the salt, a soak or a rapid program
should be run to remove the excess salt.
Adjusting Salt Consumption
Please follow the steps below for adjustment in salt consumption.
Step 1: Enter the status of salt adjustment
Close the door, switch on the appliance. Within 60 seconds after the appliance was switched
on, press Program button and hold for 5 seconds, the appliance will enter setting mode.
Step 2: select a certain level of salt consumption
Press the Program button to select the proper set according to your local environment, the
sets will change in the following sequence: H1->H2->H3->H4->H5->H6.
Step 3: Exit the status of salt adjustment
Press the Power button to end the setting mode.
There are 6 levels of salt consumption in all. It is recommended to select the level according
to below table:
Using the appliance
14 EN