VALBERG 3S58 F WAD929C Instrucciones De Uso página 24

B
NOTE
• This program is the test cycle. The information for
comparability test is in accordance with EN60436.
Turning on the appliance
Starting a wash cycle...
• Draw out the basket(see the section entitled "Loading the Dishwasher").
• Pour in the detergent (see the section"Fill the detergent").
• Insert the plug into the socket. The power supply is 220-240VAC 50Hz, the specification
of the socket is 10A 250V AC.
• Press the power button to turn on the appliance,
• Connect the inlet hose to the tap, make sure that the water supply is turned on to full
pressure, or add water the the tank manually.
• Select a suitable program according to the "Wash cycle table";
• If a program is selected, the corresponding light will be lit. Then press the Start/Pause
button, the dishwasher begins to start.
NOTE
When you press the Start/Reset button to pause during
washing,the dishwasher will beep every minute unless you
press the Start/Reset button to start.
Change the program
Premise: You can modify the washing program, if the dishwasher just worked for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water in this case, the cycle must be restarted.
• Press Start/Pause Button to pause the machine when the door is closed,
• Press Program Button for more than 3 seconds the machine will be in stand-by state,
then you can change the program to the desired cycle setting (see the section entitled
"Starting a wash program" ).
Using the appliance
22
(*EN60436)
EN