To Clean The Product - Husqvarna TS 354XD Manual De Usuario

A
A
A
A. General lubrication. Lubricate the spindle grease
connection, front wheel bearing, gear teeth of the
steering part.
B. Engine lubrication. Refer to
engine on page 29 .
Tractor

To clean the product

Do not use a garden hose or a pressure washer to
clean the surface except for the washout port. Keep
water out of the engine and transmission. Water in
the engine or transmission can decrease the life of
the product. Use compressed air or a leaf blower to
remove grass, leaves and litter.
• Clean all unwanted material from the engine,
battery, seat and other parts of the product.
• Clean contamination from the steering plate.
Contamination limits the movement of the clutch/
brake pedal shaft, causes the belt to loosen and
decreases forward movement.
CAUTION:
points and movable parts.
• Keep the surfaces and wheels free of all
gasoline, oil, and so on.
• Use automotive type wax to prevent damage to
the surfaces.
To use the deck washout port
WARNING:
locknuts in all holes in the cutting deck.
WARNING:
or missing washout fitting immediately
before you use the cutting deck.
1940 - 006 - 13.09.2022
A
A
B
To lubricate the
Avoid all pinch
Install bolts and
Replace the broken
WARNING:
washout port can cause injury to you or
others by thrown objects.
The product has a washout port as a part of the deck
washout system. Use it after each operation.
1. Move the product to a level, clear area near a
garden hose connected to a water outlet.
CAUTION:
discharge chute is far away from
buildings, parked vehicles and other
items of value. Remove the collector
chute or mulch cover if necessary.
2. Make sure the attachment clutch control is in the
"DISENGAGED" position.
3. Stop the engine and engage the parking brake.
4. Put the nozzle adapter (A) onto the end of the
garden hose (B).
A
C
5. Connect the nozzle adapter on the washout port
(C) on the left side of the cutting deck.
CAUTION:
hose to make sure that the nozzle
adapter is fully connected to the deck
washout port.
6. Start the water supply.
7. Start the engine and put the throttle control in the
fast position.
CAUTION:
is clear and that there are no children
in the area when you clean the
cutting deck.
8. Sit in the seat and engage the cutting deck. Let
the cutting deck operate until it is clean.
9. Disengage the cutting deck and stop the engine.
10. Stop the water supply.
11. Disconnect the garden hose and nozzle adapter
from the deck washout port.
12. Move the product to a dry area.
13. Engage the cutting deck and let it operate until it
is dry.
A broken or missing
Make sure the
B
Pull the garden
Make sure the area
21