To Connect The Jumper Cables; To Remove The Jumper Cables - Husqvarna TS 146XK Manual De Usuario

To replace the battery
The battery is installed below the seat.
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
1. Stop the product. Refer to
page 14 .
2. Open the engine cover.
3. Remove the terminal covers (A).
A
4. Remove the bolt and the nut to disconnect the
black (negative) battery cable from the negative (-)
terminal.
WARNING:
and burn injuries. The black (negative)
battery cable must be disconnected
before you disconnect the red (positive)
battery cable.
5. Remove the bolt and the nut to disconnect the red
(positive) battery cable from the positive (+) terminal.
6. Carefully remove the battery from the product.
7. Install a new battery.
8. Connect the red (positive) battery cable to the
positive (+) terminal and tighten the bolt and the nut.
WARNING:
and burn injuries. The red (positive)
battery cable must be connected to the
positive (+) terminal before the black
(negative) battery cable is connected to
the negative (-) terminal to prevent injury
and accidental grounding.
9. Connect the black (negative) battery cable to the
negative (-) terminal and tighten the bolt and the nut.
10. Install the terminal covers.
11. Close the engine cover.
22
Risk of electrical shock and
To stop the product on
Risk of electrical shock
Risk of electrical shock

To connect the jumper cables

WARNING:
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near the
negative terminal of the weak battery.
CAUTION:
your product to start other vehicles.
1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
2. Connect the other end of the red battery cable to the
POSITIVE (+) battery terminal (B) on the charged
battery.
WARNING:
the red battery cable touch the chassis.
This will cause a short circuit.
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the charged
battery.
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.

To remove the jumper cables

Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
Risk of explosion because
Do not use the battery of
C
D
Do not let the ends of
1939 - 003 - 25.08.2022