Noise/Vibration Information; Declaration Of Conformity - Würth STP 28-A Traducción Del Manual De Instrucciones De Servicio Original

STP 28-A.book Seite 18 Mittwoch, 6. März 2019 8:50 08
When transporting batteries:
Ensure that battery contact terminals are protected
and insulated to prevent short circuit.
Ensure that battery pack is secured against move-
ment within packaging.
Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice.
Warranty
For this Würth machine, we provide a warranty in
accordance with statutory/country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has oc-
curred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth compressed-air and power tools.

Noise/Vibration Information

Measured values determined
EN 62841.
Typically, the A-weighted noise levels of the tool are:
Sound pressure level 85 dB (A); Sound power level
96 dB (A). Uncertainty K = 3 dB.
Wear ear protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 62841.
Rough grinding*: Overall vibrational value
2
a = 10 m/s . Uncertainty K = 1.5 m/s
h
*with saw blade T101B, dimension 75 x 8 x 1,4 mm
and tooth pitch 2,5 mm.
Sanding with sanding discs*: Overall vibrational
2
value a = 9 m/s . Uncertainty K = 1.5 m/s
h
*with saw blade T118A, dimension 55 x 8 x 1 mm
and tooth pitch 1,2 mm.
The vibration emission level given in this information
sheet has been measured in accordance with a
standardised test given in EN 62841 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of the vibrational
impact.
18
The declared vibration emission level represents the
main applications of the power tool. However if the
power tool is used for other applications, with differ-
ent accessories or poorly maintained, the vibration
emission may differ. This may significantly increase
the vibrational impact over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the ex-
posure level over the total working period.
Identify additional safety measures to protect the op-
erator from the effects of vibration such as: Maintain
the power tool and the accessories, keep the hands
warm, organisation of work patterns.
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
EN 62841-1:2015,
EN 62841-2-11:2016+A1:2017,
EN 55014-1:2017,
EN 55014-2:2015,
EN 50581:2012, according to the provisions of the
according to
regulations 2011/65/EU, 2006/42/EC,
2014/30/EU.
Technical file at:
Adolf Würth GmbH & Co. KG, Abt. PPT
Reinhold-Würth-Straße 12 - 17,
74653 Künzelsau, GERMANY
2
,
Frank Wolpert
Head of Product
Management,
2
Authorized Signatory
,
Künzelsau: 06.03.2019
Subject to change without notice

Declaration of Conformity

Dr.-Ing. Siegfried Beichter
Head of Quality,
Authorized Signatory