Silver 5/8" Machine Screw - Sauder Carson Forge 419575 Manual De Instalación

Step 24
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the right diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the LEFT DOOR (K) to the LEFT END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each SCREW a
few turns before completely tightening any of them.
Repeat this step for the other DOORS (L, M, and N).
å
NOTE: For the SMALL DOORS (M and N), fasten the bottom hinges fi rst.
å
Fasten the PULL (53K) to the SMALL LEFT DOOR (N). Use two SILVER 5/8"
å
MACHINE SCREWS (15S). Repeat this step for the SMALL RIGHT DOOR (M).
Fasten a STRIKE PLATE (6I) to the LEFT DOOR (K). Use one BLACK 1/2"
å
FLAT HEAD SCREW (11S).
Fasten a SLIDE CATCH (6J) to the upper corner of the LEFT DOOR (K).
å
Use two BROWN 1" FLAT HEAD SCREWS (12S).
Fasten a SLIDE CATCH (6J) to the lower corner of the LEFT DOOR (K).
å
Use two WASHERS (9I) and two BROWN 1" FLAT HEAD SCREWS (12S).
NOTE: The SLIDE CATCHES on the LEFT DOOR (K) will slide
å
into the holes in the FRONT MOLDING (P) and DOOR STOP (X).
BLACK 1/2" FLAT HEAD SCREW
(1 used for the STRIKE PLATE)
BROWN 1" FLAT HEAD SCREW
(4 used for the SLIDE CATCHES)
Page 28
6I
11S
9I
12S

SILVER 5/8" MACHINE SCREW

(4 used for the PULLS)
P
6J
K
6J
53K
15S
419575
Stop
13H
Mounting
screw
Hinge
14H
Hinge
B
X
N
www.sauder.com/services
Stop
Mounting
screw