Control Board - Pit Boss SAVANNAH Manual De Instrucciones

A
D
A Power Button
Press once to turn on. Press and hold for three
seconds to turn off. Button will glow blue if unit
is connected to a power source.
B "P" Set Button
Use this button when the Controller Knob is set
to SMOKE (S) to control the cycle rate of the
auger feeding pellets to the burn pot.
C Controller Knob
Increase or decrease the temperature value. Push
to activate a value change, rotate to select value,
then push again to select/accept new value.
D Prime Button
Press and hold to activate an extra feed of pellets
to the burn pot.
E Meat Probe Connection Ports
Plug-in the adapter end of a meat probe to a
connection port. The readout will appear on the
display screen for the corresponding meat probe
selected.
F COOK Temperature
Displays the desired Cook temperature. This is
the temperature that is selected by turning the
Controller Knob.
WWW.PITBOSS-GRILLS.COM

CONTROL BOARD

B
E
F
K
G "P" SET Cycle
Displays the "P" Set cycle rate chosen. The cycle
rate is selected by lightly pushing the "P" Set
button, cycling from P0 to P7.
H ACTUAL Temperature
Displays the Actual temperature from inside the
main barrel. Readout is taken by the grill probe
(sensor).
I Fire Intensity Meter
Displays the Actual temperature intensity of
the fire in the burn pot, changing from blue to
red. The color changes when the desired Cook
temperature is adjusted.
J Operation Icons
A solid icon is visible when a part is in operation.
When an icon is flashing, an error has occurred.
See Troubleshooting for assistance.
K Meat Probe Readouts
Displays the temperature reading of the meat
probe (or probes) that are connected. The readout
corresponds with the plug-in connection port
selected.
C
G
H
I
J
7
HAVE A
QUESTION?
Check out some
common FAQs online
or Live Chat with
Customer Care.
PIT BOSS® GRILLS