Symbols Used In This Manual; Symbols On The Power Tool; For Your Safety; Intended Use - Flex DGE 25 18.0-EC Instrucciones De Funcionamiento

DGE 25 18.0-EC

Symbols used in this manual

WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAU TION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
N OTE
Denotes application tips and important
information.

Symbols on the power tool

V Volts
/min Rotation rate
To reduce the risk of injury, read the
operating instructions!
Disposal information for the old
machine (see page 21)!

For your safety

WARNING!
Before using the power tool, please read the
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool may
be a danger to life and limb of the user or a third
party, or the power tool or other property may be
damaged.
The cordless straight grinder may be used only
as intended,
in perfect working order.
Faults which impair safety must be repaired
immediately.

Intended use

The cordless straight grinder is intended
– for commercial use in industry and trade,
– for grinding, cutting, polishing and wire
brushing of wood, plastic and metal.
Safety instructions for straight
grinder
Safety instructions for all
operations
Safety warnings common for
grinding, sanding, wire brushing,
polishing, carving or abrasive
cutting-off operations:
■ This power tool is intended to function
as a grinder, sander, wire brush, polisher,
carving or cut-off tool. Read all safety
warnings, instructions, illustrations and
specifications provided with this power
tool. Failure to follow all instructions listed
below may result in electric shock, fire and/
or serious injury.
■ Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
■ The rated speed of the grinding
accessories must be at least equal to the
maximum speed marked on the power
tool. Grinding accessories running faster
than their rated speed can break and fly
apart.
■ The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately controlled.
■ The arbour size of wheels, sanding drums
or any other accessory must properly
fit the spindle or collet of the power
tool. Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively and
may cause loss of control.
15