Symbols Used In This Manual; Symbols On The Power Tool; For Your Safety; Noise And Vibration - Flex IW 1/2 750 18.0-EC Instrucciones De Funcionamiento Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35

Symbols used in this manual

WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
NOTE
Denotes application tips and important
information.

Symbols on the power tool

V
Volts
/min
Rotation rate
To reduce the risk of injury, read the
operating instructions!
Disposal information for the old
machine (see page 19)!

For your safety

WARNING!
Before using the power tool, please read the
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool may
be a danger to life and limb of the user or a third
party, or the power tool or other property may be
damaged.
The cordless impact wrench may be used only
as intended,
in perfect working order.
14
Faults which impair safety must be repaired
immediately.
Intended use
The cordless impact wrench is intended
– for commercial use in industry and trade,
– for fastening and loosening of bolts, nuts
and various threaded fasteners.
Safety instructions for impact
wrench
WARNING!
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury. Save all
warnings and instructions for future reference.
■ Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden
wiring or its own cord. Fasteners
contacting a "live" wire may make exposed
metal parts of the power tool "live" and
could give the operator an electric shock.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value:
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardized in EN 62841 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
IW 1/2" 750 18.0-EC
:
87,0 dB(A)
pA
:
98,0 dB(A)
WA
K = 3 dB
:
17,88 m/s
h
K = 1.5 m/s
2
2

Publicidad

Tabla de contenido
loading

Tabla de contenido