Setting The Time - Bauknecht BIK5 DP8FS2 ES Manual De Instrucciones

FIRSY TIME USE

1. SETTING THE TIME

You will need to set the time when you switch on the
oven for the first time.
The two digits for the hour will start flashing: Turn the
knob to set the hour and press
The two digits for the minutes will start flashing. Turn
the knob to set the minutes and press
Please note: To change the time at a later point, press and
hold for at least one second while the oven is off and
repeat the steps above.
You may need to set the time again following lengthy power
outages.
2. SETTINGS
If required, you can change the default unit of
measurement, temperature (°C) and rated current (16
A).
With the oven off, press and hold
seconds.
to confirm.
to confirm.
for at least 5
Turn the knob to select the unit of measurement, then
press to confirm.
Turn the selection knob to select the power
consumption, then press
Please note: The oven is programmed to consume a level of
electrical power that is compatible with a domestic network
that has a rating of more than 3 kW (16 A): If your household
uses a lower power, you will need to decrease this value (13 A).
3. HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal. Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours.
Remove any protective cardboard or transparent film
from the oven and remove any accessories from inside
it. Heat the oven to 200 °C for around one hour, ideally
using a function with air circulation (e.g. "Forced Air"
or "Convection Bake").
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the first time.
to confirm.